©

RFbeam Microwave GmbH | Schuppisstrasse 7 | CH-9016 St. Gallen |

www.rfbeam.ch | K-LD2-EVAL | data sheet

06/2017- Revision A | Page 1/13

– Powerful control panel software included

– Easy K-LD2 parameter setting over GUI

– Converted units for easy development

– Real-time streaming of ADC values and FFT spectrum

– Saves time to market and reduces NRE

– Optimizing parameters for the K-LD2 sensor in your application

– Getting started with the K-LD2

– Learning about the potential of a K-LD2 sensor

The K-LD2 Evaluation Kit is a fully operational movement detec-

tor. The evaluation board visualises the two digital outputs of the

K-LD2 over LED’s. Two potentiometers allow quick adjustments

of the sensor’s sensitivity and hold time.

With the included powerful Control Panel software, development

time is reduced drastically. All the parameters can be modified

using the Control Panel, without having to look at the command

list of the K-LD2. The influence of changed parameters can be

directly checked in the real-time spectrum. Also ADC values and

the dominant movements are displayed at the same time. Other

parameters like sensitivity, filters and thresholds are directly shown

in the spectrum to allow visual control. A unit conversion function

allows to see spectrum and detection information either in bin,

Hz or km/h. Simply save different settings of your K-LD2 and

load them later for comparison or to order preprogramed K-LD2

sensors from RFbeam.

Features

Applications

Description

data sheet

K-LD2-EVAL

radar transceiver

Figure 1: Control Panel GUI overview

Control Panel