8 / 21 page
Preliminary Datasheet
SMB365
Three-axis accelerometer
Bosch Sensortec
4
Memory
4.1
EEPROM
An EEPROM is used to store the non-volatile data, calibration parameters and the current working
modes. These are in detail
-
g-range (2g or 10g)
-
operation mode (full performance, low-power, standby)
-
interrupt mode (global or independent)
-
interrupt acceleration threshold and hysteresis level
-
self test.
4.1.1
Register Arithmetic
The following arithmetics are used for memory registers.
Register
Format
Bit width
AX|Y|Z (acceleration values)
2's complement
10
THRESHOLD
(TH or TH_X|Y|Z)
unsigned positive
either 5 or 7
HYSTERESIS
(HY or HY_X|Y|Z)
unsigned positive
either 3 or 7
Rev. 1.2
Page 8
© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such as
copying and passing on to third parties. BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Germany.
7211RB11
.