KA2143B

R/G/B VIDEO AMPLIFIER WITH OSD INTERFACE FOR MONITORS

10

NOTES;

1.

Absolute maximum rating indicates limit beyond which damage to the device may occur.

2.

Operating ratings indicate conditions for which the device is functional but do not guarantee specific performance limits.

For guaranteed specifications and test conditions, See the Electrical Characteristics. The guaranteed specifications

apply only for the test conditions listed. Some performance characteristics may degrade when the device is not

operated under the listed test conditions.

3.

4.

(pin 18) also depends on the output load.

5.

Output voltage is dependent on load resistor. Test circuit uses RL = 390

Ω.

6.

7.

∆Av track is a measure of the ability of any two amplifiers to track each other and quantifies the matching of the three

attenuators. It is the difference in gain change between any two amplifiers with the contrast voltage (V10) at either 4V

or 2V measured relative to an Avmax condition V10 = 4V. For example, at AVmax the three amplifier` gains might be

17.1dB. 16.9dB, and 16.8dB and change to 11.2dB, 10.9dB and 10.7dB respectively for V10 = 2V. This yields the

measured typical

+ 0.1dB channel tracking.

8.

When measuring video amplifier bandwidth or pulse rise and fall times, a double sided full ground plane printed circuit

board without socket is recommended. Video amplifier 10MHz isolation test also requires this printed circuit board.

The reason for a double sided full ground plane PCB is that large measurement variations occur in single sided PCB.

9.

Adjust input frequency from 10MHz (Avmax reference level ) to the - 3dB frequency (f -3dB).

10. Measure output levels of the other two undriven amplifiers relative to the driven amplifier to determine channel separation.

Terminate the undriven amplifier inputs to simulate generator loading. Repeat test at fin = 10MHz for Iso_10MHz.

11. A minimum pulse width of 200 ns is guaranteed for a horizontal line of 15kHz.

This limit is guaranteed by design. If a lower line rate is used a longer clamp pulse may be required.

12. During the AC test the 4V DC level is the center voltage of the AC output signal .

wave form will be inverted from the one shown in AC Test Circuit. Thus tr (OSD S) is actually a fall time and t

f

(OSD S)

is actually a rise time in this condition.

14. These parameters are not tested on each product which is controlled by an internal qualification procedure.