SPEC No.

LCY-1210401A

MODEL No.

LS027B7DH01

PAGE

5

[Other Notice]

(1) Operation outside specified environmental conditions cannot be guaranteed.

(2) As power supply (VDD-GND、VDDA-GND) impedance is lowered during use, bus controller should be inserted

near LCD module as much as possible.

(3) Polarizer film is applied over LCD panel surface. Liquid crystal inside LCD panel deteriorates with ultraviolet ray.

The panel should not be left in direct sun or under strong ultraviolet ray for prolonged period of time even with the

polarizer film.

(4) Disassembling the LCD module will cause permanent damage to the module. Do not disassemble the module.

(5) If LCD panel is broken, do not ingest the liquid crystal from the broken panel. If hand, leg, or clothes come in

contact with liquid crystal, wash off immediately with soap.

(6) ODS (specific chlorofuorocarbon, specific halon, 1-1-1 trichloroethane, carbon tetrachloride) are not used or

contained in material or all production processes of this product.

(7) Observe all other precautionary requirements in handling general electronic components.

Discarding liquid crystal modules

LCD Panel

: Dispose of as glass waste. This LCD module contains no harmful substances.

The liquid crystal panel contains no dangerous or harmful substances.

This liquid crystal panel contains only an extremely small amount of liquid crystal

(approximately 100mg) and therefore it will not leak even if the panel should break.

Its median lethal dose (LD50) is greater than 2,000 mg/kg and a mutagenetic

(Aims test: negative) material is used.

FPC

:

(1) FPC bend R should be 0.45mm or greater and R should be even.

In LCD panel an connective area, do not bend FPC into polarizer film side.

(2) Do not hang LCD module by FPC or apply force to FPC.