Data Sheet S17332EJ1V0DS

9

6. ELECTRICAL SPECIFICATIONS

°C, glass epoxy board of 100 mm x 100 mm x 1 mm with copper foil area

of 15%)

Parameter

Symbol

Condition

Rating

Unit

Power supply voltage

Control block

−0.5 to +6.0

V

Analog block

−0.5 to +6.0

V

Stepping motor block

−0.5 to +6.0

V

IRIS block

−0.5 to +6.0

V

Input voltage

Note1

V

Output pin voltage 1

Motor block

6.2

V

Output pin voltage 2

Amplifier block

V

DC output current

DC (stepping motor)

±0.3

A/ch

DC (IRIS)

±0.2

A/ch

Instantaneous output current

PW < 10 ms, Duty Cycle

≤ 20%

±0.7

A/ch

Power consumption

1.0

W

Peak junction temperature

Note2

150

°C

Storage temperature

−55 to +150

°C

°C. When overheat is detected, all the circuits are

stopped. The overheat protection circuit does not operate at reset or on detection of ULVO.

Caution Product quality may suffer if the absolute maximum rating is exceeded even momentarily for any

parameter. That is, the absolute maximum ratings are rated values at which the product is on the

verge of suffering physical damage, and therefore the product must be used under conditions that

ensure that the absolute maximum ratings are not exceeded.

°C, glass epoxy board of 100 mm x 100 mm x 1 mm with copper

foil area of 15%)

Parameter

Symbol

Condition

MIN.

TYP.

MAX.

Unit

Power supply voltage

Control block

2.7

3.6

V

Analog block

4.5

5.5

V

Stepping motor block

2.7

5.5

V

IRIS block

2.7

5.5

V

Input voltage

0

V

DC output current

DC (stepping motor, when 2 chs are

driven at same time)

−0.2

+0.2

A/ch

DC (IRIS), maximum current when

the shutter operates

−0.1

+0.1

A/ch

Amplifier output current

AMP1 to AMP3

−5

+5

mA/ch

Amplifier output sink current

AMP4

0

+5

mA

Logic input frequency

100

kHz

Operating temperature range

−10

70

°C

Caution Design each output current so that the junction temperature does not exceed 150ºC.