Exposed Pad

Connect to GND

5

SS

6

FB

3

EN

1

VIN

2

RON

4

GND

7

VOUT

LMZ14201EXT

www.ti.com

SNVS664H – JUNE 2010 – REVISED OCTOBER 2015

5 Pin Configuration and Functions

NDW Package

7-Pin TO-PMOD

Top View

Pin Functions

PIN

TYPE

DESCRIPTION

NAME

NO.

Enable — Input to the precision enable comparator. Rising threshold is 1.18 V nominal; 90 mV

EN

3

Analog

hysteresis nominal. Maximum recommended input level is 6.5 V.

Exposed Pad — Internally connected to pin 4. Used to dissipate heat from the package during

EP

—

Ground

operation. Must be electrically connected to pin 4 external to the package.

Feedback — Internally connected to the regulation, overvoltage, and short circuit comparators.

FB

6

Analog

The regulation reference point is 0.8 V at this input pin. Connected the feedback resistor divider

between the output and ground to set the output voltage.

GND

4

Ground

Ground — Reference point for all stated voltages. Must be externally connected to EP.

RON

2

Analog

Typical values range from 25 k

Ω to 124 kΩ.

Soft-Start — An internal 8-µA current source charges an external capacitor to produce the soft-

SS

5

Analog

start function. This node is discharged at 200 µA during disable, overcurrent, thermal shutdown

and internal UVLO conditions.

Supply input — Nominal operating range is 6 V to 42 V. A small amount of internal capacitance

VIN

1

Power

is contained within the package assembly. Additional external input capacitance is required

between this pin and exposed pad.

Output Voltage — Output from the internal inductor. Connect the output capacitor between this

VOUT

7

Power

pin and exposed pad.

6 Specifications

6.1 Absolute Maximum Ratings

over operating free-air temperature range (unless otherwise noted)

(1) (2)

MIN

MAX

UNIT

VIN, RON to GND

–0.3

43.5

V

EN, FB, SS to GND

–0.3

7

V

Junction Temperature

150

°C

Peak Reflow Case Temperature (30 sec)

245

°C

Storage Temperature

–65

150

°C

(1)

Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings

only, which do not imply functional operation of the device at these or any other conditions beyond those indicated under Recommended

Operating Conditions. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

(2)

For soldering specifications, refer to Absolute Maximum Ratings for Soldering, (SNOA549).

6.2 ESD Ratings

VALUE

UNIT

Electrostatic discharge

±2000

V

(1)

JEDEC document JEP155 states that 500-V HBM allows safe manufacturing with a standard ESD control process.

(2)

The human body model is a 100-pF capacitor discharged through a 1.5-k

Ω resistor into each pin. Test method is per JESD-22-114.

Copyright © 2010–2015, Texas Instruments Incorporated

Submit Documentation Feedback

3

Product Folder Links: LMZ14201EXT