Os motores de busca de Datasheet de Componentes eletrônicos
  Portuguese  ▼
ALLDATASHEETPT.COM

X  

ILC7071AIM527X Folha de dados(PDF) 8 Page - Fairchild Semiconductor

Nome de Peças ILC7071AIM527X
Descrição Electrónicos  100mA SOT-23-5 Low Noise CMOS RF-LDO Regulator
Download  11 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
Fabricante Electrônico  FAIRCHILD [Fairchild Semiconductor]
Página de início  http://www.fairchildsemi.com
Logo FAIRCHILD - Fairchild Semiconductor

ILC7071AIM527X Folha de dados(HTML) 8 Page - Fairchild Semiconductor

Back Button ILC7071AIM527X Datasheet HTML 3Page - Fairchild Semiconductor ILC7071AIM527X Datasheet HTML 4Page - Fairchild Semiconductor ILC7071AIM527X Datasheet HTML 5Page - Fairchild Semiconductor ILC7071AIM527X Datasheet HTML 6Page - Fairchild Semiconductor ILC7071AIM527X Datasheet HTML 7Page - Fairchild Semiconductor ILC7071AIM527X Datasheet HTML 8Page - Fairchild Semiconductor ILC7071AIM527X Datasheet HTML 9Page - Fairchild Semiconductor ILC7071AIM527X Datasheet HTML 10Page - Fairchild Semiconductor ILC7071AIM527X Datasheet HTML 11Page - Fairchild Semiconductor  
Zoom Inzoom in Zoom Outzoom out
 8 / 11 page
background image
ILC7071
PRODUCT SPECIFICATION
8
REV. 1.0.2 7/16/03
Application Information
Capacitor Selection
In general, ceramic capacitors are preferred due to their
superior ESR performance. Those with X5R dielectric offer
the best temperature coefficient.
An input capacitor of 1µF or greater, connected between
Input and Ground, located in close proximity to the device
will improve the transient response and the noise rejection.
An output capacitor of at least 1µF is required to maintain
regulator loop stability. Stable operation will be achieved
with a wide variety of capacitors with ESR ranging from
10m
Ω to 10Ω.
An optional capacitor connected between the CN pin and
ground can significantly reduce noise on the output.Values
ranging up to 10nF can be used, depending upon the sensi-
tivity to output noise in the application. Care should be taken
to prevent noise from external sources to enter into the CN
pin, which is a very sensitive, high impedance pin. Leakage
currents into this pin will directly affect the regulator accu-
racy and should be kept as low as possible.
Control Functions
Enable Pin
Applying a voltage of 0.6V or less at the Enable pin will
disable the output, reducing the quiescent output current to
less than 1µA, while a voltage of 2V or greater will enable
the device. If this shutdown function is not needed, the pin
can simply be connected to the VIN pin. Allowing this pin to
float will cause erratic operation.
Thermal Protection
The ILC7071 is designed to supply high peak output currents
for brief periods, however this output load will cause the
device temperature to increase and exceed maximum ratings
due to power dissipation. During output overload conditions,
when the die temperature exceeds the shutdown limit tem-
perature of 125 °C, onboard thermal protection will disable
the output until the temperature drops below this limit,at
which point the output is then re-enabled.
During a thermal shutdown situation the user may assert the
power-down function at the Enable pin, reducing power
consumption to the minimum level.
Thermal Characteristics
The ILC7071 is designed to supply up to 100mA at the
specified output voltage with an operating die (junction)
temperature of up to 125 °C. While the power dissipation is
calculated from known electrical parameters, the thermal
resistance is a result of the thermal characteristics of the
compact SOT-23-5 surface-mount package and the surround-
ing PC Board copper to which it is mounted.
The relationship describing the thermal behavior of the pack-
age is:
where TJ(max) is the maximum allowable junction tempera-
ture of the die, which is 125 °C, and TA is the ambient
operating temperature.
ΘJA is dependent on the surrounding
PC board layout and can be empirically obtained. While the
ΘJC (junction-to-case) of the SOT-23-5 package is specified
at 130 °C/W, the
ΘJA of the minimum PWB footprint will be
at least 235 °C/W.
This can be improved upon by providing a heat sink of
surrounding copper ground on the PCB.
Depending on the size of the copper area, the resulting
ΘJA
can range from approximately 180 °C/W for one square
inch, to nearly 130 °C/W for 4 square inches.
The addition of backside copper with through-holes, stiffen-
ers, and other enhancements can also aid in reducing this
value. The heat contributed by the dissipation of other
devices located nearby must be included in design consider-
ations.
Once the limiting parameters in the thermal relationship
have been determined, the electrical design should be
verified to ensure that the device remains within specified
operating conditions.
If overload conditions are not considered, it is possible for
the device to enter a thermal cycling loop, in which the
circuit enters a shutdown condition, cools, reenables, and
then again overheats and shuts down repeatedly due to an
unmanaged fault condition.
P
D max
()
T
Jmax
() TA
Θ
JA
--------------------------------
=


Nº de peça semelhante - ILC7071AIM527X

Fabricante ElectrônicoNome de PeçasFolha de dadosDescrição Electrónicos
logo
Impala Linear Corporati...
ILC7071AIM5-28 IMPALA-ILC7071AIM5-28 Datasheet
40Kb / 4P
   100MA SOT-23-5 ULTRA LOW NOISE CMOS RF-LDO REGULATOR
ILC7071AIM5-30 IMPALA-ILC7071AIM5-30 Datasheet
40Kb / 4P
   100MA SOT-23-5 ULTRA LOW NOISE CMOS RF-LDO REGULATOR
ILC7071AIM5-33 IMPALA-ILC7071AIM5-33 Datasheet
40Kb / 4P
   100MA SOT-23-5 ULTRA LOW NOISE CMOS RF-LDO REGULATOR
ILC7071AIM5-36 IMPALA-ILC7071AIM5-36 Datasheet
40Kb / 4P
   100MA SOT-23-5 ULTRA LOW NOISE CMOS RF-LDO REGULATOR
ILC7071AIM5-47 IMPALA-ILC7071AIM5-47 Datasheet
40Kb / 4P
   100MA SOT-23-5 ULTRA LOW NOISE CMOS RF-LDO REGULATOR
More results

Descrição semelhante - ILC7071AIM527X

Fabricante ElectrônicoNome de PeçasFolha de dadosDescrição Electrónicos
logo
Impala Linear Corporati...
ILC7071 IMPALA-ILC7071 Datasheet
40Kb / 4P
   100MA SOT-23-5 ULTRA LOW NOISE CMOS RF-LDO REGULATOR
logo
Fairchild Semiconductor
ILC7083 FAIRCHILD-ILC7083 Datasheet
472Kb / 16P
   150mA SOT-23 Low Noise CMOS RF-LDO??Regulator
logo
Impala Linear Corporati...
ILC7082 IMPALA-ILC7082 Datasheet
333Kb / 16P
   150MA SOT-23 ULTRA LOW NOISE CMOS RF-LDO REGULATOR
logo
Fairchild Semiconductor
ILC7080 FAIRCHILD-ILC7080 Datasheet
574Kb / 16P
   50/100mA SOT-23 CMOS RF LDO Regulators
ILC7082 FAIRCHILD-ILC7082 Datasheet
205Kb / 16P
   150mA SOT-23 Low Noise CMOS RF-LDOTM Regulator
logo
Linear Technology
LT1761 LINER-LT1761 Datasheet
246Kb / 16P
   100mA, Low Noise, LDO Micropower Regulators in SOT-23
LT1761 LINER-LT1761_1 Datasheet
260Kb / 20P
   100mA, Low Noise,LDO Micropower Regulators in SOT-23
logo
Impala Linear Corporati...
ILC7070 IMPALA-ILC7070 Datasheet
321Kb / 6P
   SOT-23 CMOS LDO REGULATOR WITH SHUTDOWN
ILC7062 IMPALA-ILC7062 Datasheet
379Kb / 6P
   SOT-23 CMOS LDO
ILC7080 IMPALA-ILC7080 Datasheet
424Kb / 16P
   50/100M SOT-23 CMOS RF LDO REGULATORS
More results


Html Pages

1 2 3 4 5 6 7 8 9 10 11


Folha de dados Download

Go To PDF Page


Ligação URL




Privacy Policy
ALLDATASHEETPT.COM
ALLDATASHEET é útil para você?  [ DONATE ] 

Sobre Alldatasheet   |   Publicidade   |   Contato conosco   |   Privacy Policy   |   roca de Link   |   Lista de Fabricantes
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com