Os motores de busca de Datasheet de Componentes eletrônicos |
|
TS321I Folha de dados(PDF) 4 Page - STMicroelectronics |
|
TS321I Folha de dados(HTML) 4 Page - STMicroelectronics |
4 / 8 page Notes : 1. Short-circuits from the output to VCC can cause excessive heating if VCC > 15V. The maximum output current is approximately 40mA independent of the magnitude of VCC. 2. The direction of the input current is out of the IC. This current is essentially constant, independent of the state of the output so no loading change exists on the input lines. 3. Vo = 1.4V, Rs = 0 Ω,5V < VCC+ < 30V, 0 < Vic <VCC+ - 1.5V. 4. The input common-mode voltage of either input signal voltage should not be allowed to go negative by more than 0.3V. The upper end of the common-mode voltage range is VCC + - 1.5V, but either or both inputs can go to +32V without damage. 5. This input current only exists when the voltage at any of the input leads is driven negative. It is due to the collector-base junction of the input PNP transistor becoming forward biased and thereby acting as input diodes clamps. In addition to this diode action, there is also NPN parasitic action on the IC chip. this transistor action can cause the output voltages of the Op-amps to go to the VCC voltage level (or to ground for a large overdrive) for the time duration than an input is driven negative. This is not destructive and normal output will set up again for input voltage higher than -0.3V. ELECTRICAL CHARACTERISTICS VCC + = +5V, VCC– = Ground, VO = 1.4V, Tamb = +25oC (unless otherwise specified) Symbol Parameter Min. Typ. Max. Unit VOH High Level Output Voltage (VCC = +30V) Tamb = +25 oCRL =2k Ω Tmin. ≤ Tamb ≤ Tmax. Tamb = +25 oCRL = 10kΩ Tmin. ≤ Tamb ≤ Tmax. (VCC = +5V, RL =2k Ω) Tamb = +25 oC Tmin. ≤ Tamb ≤ Tmax. 26 25.5 27 26.5 3.5 3 27 28 V VOL Low Level Output Voltage (RL =10k Ω) Tamb = +25 oC Tmin. ≤ Tamb ≤ Tmax. 515 20 mV SR Slew Rate VCC = 15V, VI = 0.5 to 3V, RL =2k Ω, CL = 100pF, Tamb = +25 oC, unity gain) 0.4 V/ µs GBP Gain Bandwidth Product VCC = 30V, f = 100kHz, Tamb = +25 oC, Vin =10mV, RL =2k Ω,CL = 100pF 0.8 MHz ∅m Phase Margin 60 Degrees THD Total Harmonic Distortion f = 1kHz, AV = 20dB, RL =2k Ω, VO =2Vpp,CL = 100pF, Tamb = +25 oC, VCC = 30V 0.015 % en Equivalent Input Noise Voltage f = 1kHz, Rs = 100 Ω,VCC = 30V 40 nV √ Hz TS321 4/8 |
Nº de peça semelhante - TS321I |
|
Descrição semelhante - TS321I |
|
|
Ligação URL |
Privacy Policy |
ALLDATASHEETPT.COM |
ALLDATASHEET é útil para você? [ DONATE ] |
Sobre Alldatasheet | Publicidade | Contato conosco | Privacy Policy | roca de Link | Lista de Fabricantes All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |