SS-I CS-2459 09/01/06

Page 1 of 2

Features

• Sleek, low-profile design.

• Addressable-analog communica-

tion.

• Stable communication technique

with noise immunity.

• Low standby current.

• Two-wire SLC connection.

• Rotary, decimal addressing (1 –

99).

• Optional remote, single-gang LED

accessory (RA400Z).

• Dual LED design provides 360°

viewing angle.

• Visible bicolor LEDs blink green

every time the detector is ad-

dressed, and illuminate steady red

on alarm.

• Remote test feature from the

panel.

• Built-in functional test switch

activated by external magnet.

• Built-in tamper-resistant feature.

• Sealed against back pressure.

• Constructed of off-white

Bayblend®, designed to commer-

cial standards, and offers an

attractive appearance.

• 94-5V plastic flammability rating.

• SEMS screws for wiring of the

separate base.

• Optional relay, isolator, or sounder

bases.

• Backward-compatible.

Listings

Listings and approvals below

apply to the SS-I Intelligent Plug-In

Ionization Smoke Detector. In

some cases, the detector may not

be listed by certain approval

agencies, or listing may be in

process. Consult factory for latest

listing status.

• UL Listed: file S1195.

• CSFM approved:

file 7271-1288:168.

SS-I

Intelligent Addressable Plug-In

Ionization Smoke Detector

Description

Gamewell’s

intelligent

detector with integral commu-

nication provides features

that surpass conventional de-

tectors. Detector sensitivity

can be programmed in the

control panel software. Sen-

sitivity is continuously moni-

tored and reported to the

panel. Point ID capability al-

lows each detector’s address

to be set with decade address

switches, providing exact de-

tector locations for selective maintenance when chamber contamination reaches

an unacceptable level. The SS-I ionization detector incorporates a unique single-

source, dual-chamber design to respond quickly and dependably to a broad range of

fires. The SS-I detector is compatible with Gamewell’s 602, 610, 632, 654 and 658

Installation

The SS-I plug-in detector uses a separate base to simplify installation, service, and

maintenance. A special tool allows maintenance personnel to plug in and remove

detectors without using a ladder.

Mount base on an electrical backbox which is at least 1.5" (3.81 cm) deep. Suitable

mounting back boxes include:

• 4.0" (10.16 cm) square box.

• 3.5" (8.89 cm) or 4.0" (10.16 cm) octagonal box.

• Single-gang box (except for relay or isolator base).

• With B501BH or B501BHT base, use a 4.0" (10.16 cm) square box.

• With B224RB or B224BI base, use a 3.5" (8.89 cm) octagonal box, or a 4.0"

(10.16 cm) octagonal or square box.

NOTES: 1) Because of the inherent supervision provided by the SLC loop, end-of-

line resistors are not required. Wiring “T-taps” or branches are permitted for Style 4

(Class “B”) wiring. 2) When using relay or sounder bases, consult data sheet CS-

2464 (SS-LI) for device limitations between isolator modules and isolator bases.

SS-I with SS-B6 base

6934pho1.jpg

Bayblend® is a registered trademark of Bayer Corporation.