ISL31480E, ISL31483E, ISL31485E, ISL31486E

11

FN7638.0

June 25, 2010

(Figure 5)

Full

-

4

10

ns

Receiver Enable to

Output Low

(Figure 6), (Notes 12, 19)

Full

-

-

50

ns

Receiver Enable to

Output High

(Figure 6), (Notes 12, 19)

Full

-

-

50

ns

Receiver Disable from

Output Low

(Figure 6) (Note 19)

Full

-

-

50

ns

Receiver Disable from

Output High

(Figure 6) (Note 19)

Full

-

-

50

ns

Time to Shutdown

(Notes 13, 19)

Full

60

160

600

ns

Receiver Enable from

Shutdown to Output High

(Figure 6), (Notes 13, 15, 19)

Full

-

-

2000

ns

Receiver Enable from

Shutdown to Output Low

(Figure 6), (Notes 13, 15, 19)

Full

-

-

2000

ns

NOTES:

8. All currents into device pins are positive; all currents out of device pins are negative. All voltages are referenced to device

ground unless otherwise specified.

9. Supply current specification is valid for loaded drivers when DE = 0V.

10. Applies to peak current. See “Typical Performance Curves” beginning on page 18 for more information

11. Keep RE = 0 to prevent the device from entering SHDN.

12. The RE signal high time must be short enough (typically <100ns) to prevent the device from entering SHDN.

13. Transceivers (except on the ISL31485E) are put into shutdown by bringing RE high and DE low. If the inputs are in this state

for less than 60ns, the parts are guaranteed not to enter shutdown. If the inputs are in this state for at least 600ns, the parts

are guaranteed to have entered shutdown. See “Low Power Shutdown Mode” on page 17.

14. Keep RE = VCC, and set the DE signal low time >600ns to ensure that the device enters SHDN.

15. Set the RE signal high time >600ns to ensure that the device enters SHDN.

16. Parameters with MIN and/or MAX limits are 100% tested at +25°C, unless otherwise specified. Temperature limits established

by characterization and are not production tested.

17. See Figure 9 for more information, and for performance over-temperature.

18. Tested according to TIA/EIA-485-A, Section 4.2.6 (±80V for 15ms at a 1% duty cycle).

19. Does not apply to the ISL31485E. The ISL31485E has no Rx enable function, and thus no SHDN function.

20. See “Caution” statement in the “Recommended Operating Conditions” section on page 9.

Test Circuits and Waveforms

FIGURE 1B. 1B

FIGURE 1. DC DRIVER TEST CIRCUITS

range, -40°C to +85°C. (Continued)

PARAMETER

SYMBOL

TEST CONDITIONS

TEMP

(°C)

MIN

(Note 16)

TYP

MAX

(Note 16) UNITS

D

DE

DI

Z

Y

D

DE

DI

375Ω

375Ω

Z

Y