0.155 (3.94)

0.955 (24.26)

(1.02)

0.000

0.555 (14.1)

1.115 max. (28.32)

1

2

4

5

Flanged cases: Designator “F” required in Case Option position of model number.

BOTTOM VIEW CASE K2

0.162 dia

(4.11)

Dot on top of case indicates pin one

3

Flange thickness: 0.060 (1.52)

2.910 max

(73.91)

Case dimensions in inches (mm)

Tolerance ±0.005 (0.13) for three decimal places

±0.01 (0.3) for two decimal places

unless otherwise specified

CAUTION

Heat from reflow or wave soldering may damage the device. Solder pins

individually with heat application not exceeding 300°C for 10 seconds per pin.

Materials

Header

Cold Rolled Steel/Nickel/Gold

Cover

Kovar/Nickel

Pins

#52 alloy/Gold, cceramic seal.

Seal Hole: 0.120 ±0.002 (3.04 ±0.05)

Case K1 FMC F, Rev E, 20091111

Please refer to the numerical dimensions for accuracy. All information is believed to

be accurate, but no responsibility is assumed for errors or omissions. Interpoint

reserves the right to make changes in products or specifications without notice.

Copyright © 1999-2009 Interpoint Corp. All rights reserved.

Crane Aerospace & Electronics Power Solutions

FMce-0528 eMi input Filters

28 Volt input – 5 aMp

www.interpoint.com

Page 8 of 10

FMCE-0528 Rev D - 20100413