P

Copyright © 2009

Microsemi

5

Rev 1.1 27-Jul-09

Analog Mixed Signal Group

2381 Morse Avenue, Irvine, CA 92614, USA; Phone (USA): (800) 713-4113, (ROW): (949) 221-7100 Fax: (949) 756-0308

1

Safety Information

Read the following safety information before using your Power over

Ethernet Midspan unit.

1.1

General Guidelines

Read the following safety information before carrying out any installation,

removal or any maintenance procedure on the Power over Ethernet

Midspan. Warnings contain directions that must be followed for personal

and product safety. Follow all directions carefully.

WARNINGS

•

Read the Installation Instructions in Section 3 before

connecting the Power over Ethernet Midspan to its power

source.

•

The Midspan must use a grounded power cord, as

defined in Section 1.2.

•

This product relies on the building installation for short-

circuit (overcurrent) protection. Ensure that a fuse or

circuit breaker no larger than 15 A for 120 VAC, (U.S.) 10

A for 230 VAC (international) is used.

•

Do not work on the system, or connect or disconnect

cables during periods of lightning.

•

A voltage mismatch can cause equipment damage and

may pose a fire hazard. If the voltage indicated on the

label is different from the power outlet voltage, do not

connect the Power over Ethernet Midspan to this outlet.

•

For shelf-mounted equipment, be certain that the surface

is stable and strong enough to support the equipment. Do

not stack more than four Power over Ethernet Midspans

units.

•

Final disposal of this product should be handled

according to all local laws and regulations.

•

The Power over Ethernet Midspan "Data" and "Data +

Power" ports are shielded RJ-45 data sockets. They

cannot be used as Plain Old Telephone Service (POTS)

telephone sockets. Only RJ-45 data connectors may be

connected to these sockets.

•

Associated ethernet wiring shall be limited to inside of the

building.