8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE

PHOTOCOUPLER

Everlight Electronics Co., Ltd.

9

http://www.everlight.com

Document No

：DPC-0000120 Rev. 2

November 2, 2011

6N137

EL26XX series

Notes:

*3 The VCC supply must be bypassed by a 0.1µF capacitor or larger. This can be either a ceramic or solid

tantalum capacitor with good high frequency characteristic and should be connected as close as possible to

the package VCC and GND pins

*4. Enable Input – No pull up resistor required as the device has an internal pull up resistor.

*5. tPLH

– Propagation delay is measured from the 3.75mA level on the HIGH to LOW transition of the input

current pulse to the 1.5 V level on the LOW to HIGH transition of the output voltage pulse.

*6. tPHL

– Propagation delay is measured from the 3.75mA level on the LOW to HIGH transition of the input

current pulse to the 1.5 V level on the HIGH to LOW transition of the output voltage pulse.

*7. tr

– Rise time is measured from the 90% to the 10% levels on the LOW to HIGH transition of the output

pulse.

*8. tf

– Fall time is measured from the 10% to the 90% levels on the HIGH to LOW transition of the output

pulse.

*9. tELH

– Enable input propagation delay is measured from the 1.5V level on the HIGH to LOW transition of

the input voltage pulse to the 1.5V level on the LOW to HIGH transition of the output voltage pulse.

*10. tEHL

– Enable input propagation delay is measured from the 1.5V level on the LOW to HIGH transition of

the input voltage pulse to the 1.5V level on the HIGH to LOW transition of the output voltage pulse.

*11 CMH– The maximum tolerable rate of rise of the common mode voltage to ensure the output will remain in

the HIGH state (i.e., VOUT > 2.0V).

*12 CML– The maximum tolerable rate of rise of the common mode voltage to ensure the output will remain in

the LOW output state (i.e., VOUT < 0.8V).

Order Information

Part Number

6N137Y(Z)-V

Or

EL26XXY(Z)-V

Note

X

= (01 or 11) for EL26 part no.

Y

= Lead form option (S, S1, M or none)

Z

= Tape and reel option (TA, TB or none).

V

= VDE (optional)

Option

Description

Packing quantity

None

Standard DIP-8

45 units per tube

M

Wide lead bend (0.4 inch spacing)

45 units per tube

S (TA)

Surface mount lead form + TA tape & reel option

1000 units per reel

S (TB)

Surface mount lead form + TB tape & reel option

1000 units per reel

S1 (TA)

Surface mount lead form (low profile) + TA tape & reel option

1000 units per reel

S1 (TB)

Surface mount lead form (low profile) + TB tape & reel option

1000 units per reel