LM2903N datasheet(9/17 Pages) TI1

Nome de Peças	LM2903N

Descrição Electrónicos	LM193/LM293/LM393/LM2903 Low Power Low Offset Voltage Dual Comparators

Download	17 Pages

Scroll/Zoom	100%

Fabricante Electrônico	TI1 [Texas Instruments]

Página de início	http://www.ti.com

Logo

9 / 17 page

Application Hints

The LM193 series are high gain, wide bandwidth devices

which, like most comparators, can easily oscillate if the

output lead is inadvertently allowed to capacitively couple to

the inputs via stray capacitance. This shows up only during

the output voltage transition intervals as the comparator

change states. Power supply bypassing is not required to

solve this problem. Standard PC board layout is helpful as it

reduces stray input-output coupling. Reducing the input re-

sistors to < 10 k

Ω reduces the feedback signal levels and

finally, adding even a small amount (1.0 to 10 mV) of positive

feedback (hysteresis) causes such a rapid transition that

oscillations due to stray feedback are not possible. Simply

socketing the IC and attaching resistors to the pins will cause

input-output oscillations during the small transition intervals

unless hysteresis is used. If the input signal is a pulse

waveform, with relatively fast rise and fall times, hysteresis is

not required.

All input pins of any unused comparators should be tied to

the negative supply.

The bias network of the LM193 series establishes a drain

current which is independent of the magnitude of the power

supply voltage over the range of from 2.0 V

DC to 30 VDC.

It is usually unnecessary to use a bypass capacitor across

the power supply line.

The differential input voltage may be larger than V

+ without

damaging the device (Note 8). Protection should be provided

to prevent the input voltages from going negative more than

−0.3 V

DC (at 25˚C). An input clamp diode can be used as

shown in the applications section.

The output of the LM193 series is the uncommitted collector

of a grounded-emitter NPN output transistor. Many collectors

can be tied together to provide an output OR’ing function. An

output pull-up resistor can be connected to any available

power supply voltage within the permitted supply voltage

range and there is no restriction on this voltage due to the

magnitude of the voltage which is applied to the V

+ terminal

of the LM193 package. The output can also be used as a

simple SPST switch to ground (when a pull-up resistor is not

used). The amount of current which the output device can

sink is limited by the drive available (which is independent of

V

+) and the

β of this device. When the maximum current limit

is reached (approximately 16mA), the output transistor will

come out of saturation and the output voltage will rise very

rapidly. The output saturation voltage is limited by the ap-

proximately 60

Ω r

SAT of the output transistor. The low offset

voltage of the output transistor (1.0mV) allows the output to

clamp essentially to ground level for small load currents.

Typical Applications (V+=5.0 V

DC)

Basic Comparator

Driving CMOS

Driving TTL

00570935

00570936

00570937

Squarewave Oscillator

Pulse Generator

Crystal Controlled Oscillator

00570938

00570939

* For large ratios of R1/R2,

D1 can be omitted.

00570940

www.national.com

8

Nº de peça semelhante - LM2903N

Fabricante Electrônico	Nome de Peças	Folha de dados	Descrição Electrónicos
Motorola, Inc	LM2903N	136Kb / 6P	SINGLE SUPPLY, LOW POWER DUAL COMPARATORS
Fairchild Semiconductor	LM2903N	155Kb / 8P	Dual Differential Comparator
National Semiconductor ...	LM2903N	322Kb / 15P	Low Power Low Offset Voltage Dual Comparators
Texas Instruments	LM2903N	1Mb / 29P	[Old version datasheet] Low-Power, Low-Offset Voltage, Dual Comparators
NXP Semiconductors	LM2903N	121Kb / 6P	Low power dual voltage comparator 1995 Nov 27

More results

Descrição semelhante - LM2903N

Fabricante Electrônico	Nome de Peças	Folha de dados	Descrição Electrónicos
Texas Instruments	LM193-N	1Mb / 25P	[Old version datasheet] LM193/LM293/LM393/LM2903 Low Power Low Offset Voltage Dual Comparators
	LM393MX_NOPB	1Mb / 24P	[Old version datasheet] LM193/LM293/LM393/LM2903 Low Power Low Offset Voltage Dual Comparators
	LM393-N	1Mb / 24P	[Old version datasheet] LM193/LM293/LM393/LM2903 Low Power Low Offset Voltage Dual Comparators
	LM393B	2Mb / 50P	[Old version datasheet] LM393B, LM2903B, LM193, LM293, LM393 and LM2903 Dual Comparators
	LM193	1Mb / 40P	[Old version datasheet] LM193, LM293, LM393, LM2903, LM393B and LM2903B Dual Comparators
	LM193	1Mb / 46P	[Old version datasheet] LM193, LM293, LM393, LM2903, LM393B and LM2903B Dual Comparators
	LM393B	2Mb / 49P	[Old version datasheet] LM393B, LM2903B, LM193, LM293, LM393 and LM2903 Dual Comparators
	LM393B	3Mb / 55P	[Old version datasheet] LM393B, LM2903B, LM193, LM293, LM393 and LM2903 Dual Comparators
	LM193-N	1Mb / 29P	[Old version datasheet] Low-Power, Low-Offset Voltage, Dual Comparators
List of Unclassifed Man...	AZ393	238Kb / 9P	LOW POWER LOW OFFSET VOLTAGE DUAL COMPARATORS

More results

LM2903N Folha de dados(PDF) 9 Page - Texas Instruments

LM2903N Folha de dados(HTML) 9 Page - Texas Instruments

Nº de peça semelhante - LM2903N

Descrição semelhante - LM2903N

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Folha de dados Download

Ligação URL