AN-1053: SiLabs RF-to-USB2 Cymbet EH Demos

©2012 Cymbet Corporation • Tel: +1-763-633-1780 • www.cymbet.com

Doc AN-72-1053 Rev A

Page 3 of 4

d) Communication should begin after pressing the white push button SW1 on node board according to the

instructions in the Silicon Labs User’s Guide. Temperature and Potentiometer Data will be displayed on the

GUI as depicted below.

e) To vary the reading of the “Potentiometer” field in the GUI, rotate the black potentiometer wheel on the

RF-to-USB2 board. Please note the data is updated only every 10 seconds to work properly with EH power.

Occasionally, the dongle might not install correctly and a warning message will appear. If the following error

message appears, contact Silicon Labs technical support.