DAC102S085

www.ti.com

SNAS364E – MAY 2006 – REVISED MARCH 2013

Specification Definitions

DIFFERENTIAL NON-LINEARITY (DNL) is the measure of the maximum deviation from the ideal step size of 1

DAC-to-DAC CROSSTALK is the glitch impulse transferred to a DAC output in response to a full-scale change

in the output of another DAC.

DIGITAL CROSSTALK is the glitch impulse transferred to a DAC output at mid-scale in response to a full-scale

change in the input register of another DAC.

DIGITAL FEEDTHROUGH is a measure of the energy injected into the analog output of the DAC from the digital

inputs when the DAC outputs are not updated. It is measured with a full-scale code change on the data bus.

FULL-SCALE ERROR is the difference between the actual output voltage with a full scale code (3FFh) loaded

GAIN ERROR is the deviation from the ideal slope of the transfer function. It can be calculated from Zero and

Full-Scale Errors as GE = FSE - ZE, where GE is Gain error, FSE is Full-Scale Error and ZE is Zero Error.

GLITCH IMPULSE is the energy injected into the analog output when the input code to the DAC register

changes. It is specified as the area of the glitch in nanovolt-seconds.

INTEGRAL NON-LINEARITY (INL) is a measure of the deviation of each individual code from a straight line

through the input to output transfer function. The deviation of any given code from this straight line is measured

from the center of that code value. The end point method is used. INL for this product is specified over a limited

range, per the Electrical Tables.

LEAST SIGNIFICANT BIT (LSB) is the bit that has the smallest value or weight of all bits in a word. This value is

n

(1)

DAC102S085.

MAXIMUM LOAD CAPACITANCE is the maximum capacitance that can be driven by the DAC with output

stability maintained.

MONOTONICITY is the condition of being monotonic, where the DAC has an output that never decreases when

the input code increases.

MOST SIGNIFICANT BIT (MSB) is the bit that has the largest value or weight of all bits in a word. Its value is

MULTIPLYING BANDWIDTH is the frequency at which the output amplitude falls 3dB below the input sine wave

POWER EFFICIENCY is the ratio of the output current to the total supply current. The output current comes from

the power supply. The difference between the supply and output currents is the power consumed by the device

without a load.

SETTLING TIME is the time for the output to settle to within 1/2 LSB of the final value after the input code is

updated.

TOTAL HARMONIC DISTORTION (THD) is the measure of the harmonics present at the output of the DACs

WAKE-UP TIME is the time for the output to exit power-down mode. This is the time from the falling edge of the

16th SCLK pulse to when the output voltage deviates from the power-down voltage of 0V.

ZERO CODE ERROR is the output error, or voltage, present at the DAC output after a code of 000h has been

entered.

Copyright © 2006–2013, Texas Instruments Incorporated

Submit Documentation Feedback

7

Product Folder Links: DAC102S085