ITW CHEMTRONICS

®

MSDS #1611

Page 2 of 2

SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES

Physical State: Clear, colorless liquid

Solubility in Water: Negligible

Odor: Slight Ethereal Odor

Specific Gravity: 1.55

pH: NA

(Water =1)

Composite Vapor Pressure: 289 mmHg @ 68

° F

Evaporation Rate: >1 (Butyl acetate=1)

Boiling Point: 130

°F (54C)

Percent Volatile: 100%

Vapor Density: 7.0 (air = 1)

SECTION 10: STABILITY AND REACTIVITY

Stability - This product is stable.

Conditions to Avoid: Steam, oxidizers, elevated temperatures. Do not spray near open flames, red hot surfaces or other sources of ignition.

Incompatibility: Do not mix with alkali metals, pure oxygen, strong base, open flames, and welding arcs. This product should not be used in long term contact with

aluminum or zinc or their alloys.

Products of Decomposition: Thermal decomposition may release carbon monoxide, carbon dioxide and incompletely burned hydrocarbons as well as hydrochloric and

hydrofluoric acid vapor.

Hazardous Polymerization: Will not occur

Conditions to Avoid: Finely divided active metals, alkali and alkaline earth metals

SECTION 11: TOXICOLOGICAL INFORMATION

Inhalation:

Ingestion:

AK225ca / AK225cb

LC50 rat 37,300 ppm/36,800 ppm (4hr)*

AK225ca / AK225cb

LD50/rat >5000 mg/kg*

Ethanol

LC50 rat

20,000 ppm/10 hr *

Ethanol

LD50/rat

7060 mg/kg *

Tetrafluoroethane

Rat ALC 567,000ppm/4hrs*

Methanol

LD50 rat

5628 mg/kg*

Methanol

LC50 rat

64,000 ppm/4hrs*

Skin

Eye:

AK225ca / AK225cb

LD50rabbit

>2,000 mg/kg*

AK225ca / AK225cb

Not an irritant*

Ethanol

LD50rabbit

400 mg open MLD *

Ethanol

500 mg SEV *

Methanol

20mg/24H

MLD *

Methanol

rabbit

40 mg MOD *

*Information provided by manufacturer.

Cancer Information: No ingredients in this product are listed as human carcinogens by IARC or NTP.

Reproductive effects: none

Teratogenic effects: none

Mutagenic effects: none

SECTION 12: ECOLOGICAL INFORMATION

Avoid runoff into storm sewers and ditches which lead to waterways. Water runoff can cause environmental damage.

REPORTING

US regulations require reporting spills of this material that could reach any surface waters.

The toll free number for the US Coast Guard National Response Center is: 1-800-424-8802

SECTION 13: DISPOSAL CONSIDERATIONS

Dispose of in accordance with all federal, state and local regulations. Water runoff can cause environmental damage.

SECTION 14: TRANSPORTATION INFORMATION

Proper

Sub.

Pkg.

Hazard

Pkg.

Max.

Shipping Name

UN Number

Class

Risk

Group

Label

Instr.

Quantity

Air:

Aerosols non-flammable

UN 1950

2.2

NA

NA.

Non-flammable gas

203

75 k.g; 150k.g.

Ground:

Consumer Commodity

NA

ORM-D

NA

NA

ORM-D

Pkg.

173.306

ORM-D

Auth.

SECTION 15: REGULATORY INFORMATION

SECTION 313 SUPPLIER NOTIFICATION

This product contains the following chemicals subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right-To-Know Act of

1986 (40 CFR 372).

Chemical Name

CAS No.

Wt. % Range

HCFC-225ca

422-56-0

20.0 - 40.0

HCFC-225cb

507-55-1

20.0 - 40.0

Methanol

67-56-1

0.1-1.0

This information should be included on all MSDSs copied and distributed for this material.

TOXIC SUBSTANCES CONTROL ACT (TSCA).

All ingredients of this product are listed on the TSCA Inventory.

WHMIS: Class A; Class D2B

This product has been classified according to the hazard criteria of the CPR and the MSDS contains all of the information required by the CPR.

SECTION 16: OTHER INFORMATION

This product is a Level 1 aerosol. Do not puncture or incinerate containers. Normal ventilation for standard manufacturing practices is usually adequate. Local exhaust

should be used when large amounts are released. This MSDS is applicable to products manufactured after June 25, 2004 (date code of 4176 or higher).

To the best of our knowledge, the information contained herein is accurate. However, all materials may present unknown hazards and should be used with caution. In

particular, improper use of our products and their inappropriate combination with other products and substances may produce harmful results which cannot be

anticipated. Final determination of the suitability of any material is the sole responsibility of the user. Although certain hazards are described herein, we cannot

guarantee that these are the only hazards that may exist.