Os motores de busca de Datasheet de Componentes eletrônicos |
|
HCPL0630 Folha de dados(PDF) 6 Page - Agilent(Hewlett-Packard) |
|
HCPL0630 Folha de dados(HTML) 6 Page - Agilent(Hewlett-Packard) |
6 / 10 page 6 Parameter Symbol Device Min. Typ.* Max. Units Test Conditions Fig. Note Propagation Delay 75 ns T A = 25°C Time to High t PLH 20 48 7, 8, 9 3, 6 Output Level 100 ns Propagation Delay 75 ns T A = 25°C Time to Low t PHL 25 50 7, 8, 9 3, 7 Output Level 100 ns R L = 350 Ω Pulse Width |t PHL-tPLH| 3.5 35 ns C L = 15 pF 10 13 Distortion Propagation Delay t PSK 40 ns 13,14 Skew Output Rise Time t r 24 ns 11 3 (10-90%) Output Fall Time t f 10 ns 11 3 (90-10%) Common Mode HCPL-2630/0630 10,000 V CM = 10 V V O(MIN) = 2 V, Transient R L = 350 Ω, Immunity at |CM H| HCPL-2631/0631 5,000 10,000 V/ µsV CM = 50 V I F = 0 mA, 12 3, 8, High Output T A = 25°C10 Level HCPL-4661/0661 10,000 15,000 V CM = 1000 V Common Mode HCPL-2630/0630 10,000 V CM = 10 V V O(MAX) = 0.8 V, Transient R L = 350 Ω, Immunity at |CM L| HCPL-2631/0631 5,000 10,000 V/ µsV CM = 50 V I F = 7.5 mA 12 3, 9, Low Output T A = 25°C10 Level HCPL-4661/0661 10,000 15,000 V CM = 1000 V Switching Specifications Over recommended temperature (T A = -40°C to +85°C), VCC = 5 V, IF = 7.5 mA, unless otherwise specified. *All typical values are at V CC = 5 V, TA = 25°C. Notes: 1. Bypassing of the power supply line is required with a 0.1 µF ceramic disc capacitor adjacent to each optocoupler. Total lead length between both ends of the capacitor and the isolator pins should not exceed 10 mm. 2. Peaking circuits may produce transient input currents up to 50 mA, 50 ns maximum pulse width, provided average current does not exceed 15 mA. 3. Each channel. 4. Measured between pins 1, 2, 3, and 4 shorted together, and pins 5, 6, 7, and 8 shorted together. 5. Measured between pins 1 and 2 shorted together, and pins 3 and 4 shorted together. 6. The tPLH propagation delay is measured from the 3.75 mA point on the falling edge of the input pulse to the 1.5 V point on the rising edge of the output pulse. 7. The tPHL propagation delay is measured from the 3.75 mA point on the rising edge of the input pulse to the 1.5 V point on the falling edge of the output pulse. 8. CMH is the maximum tolerable rate of rise of the common mode voltage to assure that the output will remain in a high logic state (i.e., VOUT > 2.0 V). 9. CML is the maximum tolerable rate of fall of the common mode voltage to assure that the output will remain in a low logic state (i.e., VOUT < 0.8 V). 10. For sinusoidal voltages, (|dVCM|/dt)max = πfCMVCM(p-p). 11. As illustrated in Figure 15 the VCC and GND traces can be located between the input and the output leads to provide additional noise immunity at the compromise of insulation capability. 12. In accordance with UL 1577, each optocoupler is proof tested by applying an insulation test voltage ≥ 3000 V RMS for 1 second (Leakage detection current limit, II-O ≤ 5 µA). 13. See application section; “Propagation Delay, Pulse-Width Distortion and Propagation Delay Skew” for more information. 14. tPSK is equal to the worst case difference in tPHL and/or tPLH that will be seen between units at any given temperature within the operating condition range. 15. In accordance with UL 1577, each optocoupler is proof tested by applying an insulation test voltage ≥ 6000 V RMS for 1 second (Leakage detection current limit, II-O ≤ 5 µA). This option is valid for HCPL-2630/2631/4661 only. 16. Measured between the LED anode and cathode shorted together and pins 5 through 8 shorted together. 17. Derate linearly above 80 °C free-air temperature at a rate of 2.7 mW/°C for the SOIC-8 package. |
Nº de peça semelhante - HCPL0630 |
|
Descrição semelhante - HCPL0630 |
|
|
Ligação URL |
Privacy Policy |
ALLDATASHEETPT.COM |
ALLDATASHEET é útil para você? [ DONATE ] |
Sobre Alldatasheet | Publicidade | Contato conosco | Privacy Policy | roca de Link | Lista de Fabricantes All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |