CD10.241

CD-Series

DC/DC Converter 24V/24V, 10A, 240W

The input side of the DC/DC converter is equipped with a bulk capacitor which keeps the output voltage alive for a

certain period of time when the input voltage dips or is removed. The bulk capacitor can be discharged by loading the

DC/DC converter on the output side or through a load which is parallel to the input. There is no protection in the

DC/DC converter which prevents current from flowing back to the input terminals. If prevention is needed, an external

diode should be used.

Hold-up Time

typ.

8ms

at 24Vdc input and 24Vdc, 5A output, see Fig. 6-1

typ.

4ms

at 24Vdc input and 24Vdc, 10A output, see Fig. 6-1

Fig. 6-1 Hold-up time vs. input voltage

0

2

4

6

8ms

18

20

22

24

28Vdc

Input Voltage

Hold-up Time

(a) 24V, 5A, typ.

(b) 24V, 5A, min.

(c) 24V, 10A, typ.

(d) 24V, 10A, min.

26

(a)

(b)

(c)

(d)

Fig. 6-2 Shut-down test setup

Fig. 6-3 Shut-down behavior, definitions

7/25

Load

+

-

DC/DC

Converter

DC

Source

+

-

Input

Output

+

-

CD10

S1

- 5%

Hold-up Time

Output

Voltage

Intput

Voltage

S1 opens

Note: At no load, the hold-up time can be up to several seconds. The green DC-ok lamp is also on during this time.

Jul. 2017 / Rev. 1.1 DS-CD10.241-EN

All parameters are typical values at 24V, 10A, 24Vdc input voltage, 25°C ambient and

after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany